Reaction Between Hydrochloric Acid And Calcium Carbonate

The average HCl concentration of the three trails is = 0.098 M 2. Question 2: Experiment 2: The acidity and vinegar, the type of vinegar we used was Kroger distilled white vinegar, and the acidity of the vinegar was 5% Trails Dilution of original vinegar solution. Volume of

The reaction rate will be measured by the rate of production of oxygen gas as hydrogen peroxide is

In addition, phenolphthalein was added as an indicator. The aliquots were titrated against sodium hydroxide (NaOH) solution until end point was reached, after which volume of NaOH consumed was recorded. The value of the rate constant, k, obtained was 0.0002 s-1. The experiment was then repeated with 40/60 V/V isopropanol/water mixture and a larger value of k = 0.0007 s-1 was obtained. We concluded that the rate of hydrolysis of (CH3)3CCl is directly proportional to water content in the solvent mixture.

3mL of the liquid in each of the vials were added into cuvettes and measured in the spectrophotometer. Before each time point the photo spectrometer was zeroed using a cuvette with 3mL of distilled water. If any of the results were considered unusual the machine was zeroed again and the sample was retested. The results from the spectrophotometer test were recorded in a table. The experiment was repeated six times to gain a sample size of six.

Materials: The materials that I will be utilizing during these experimentations are three to four ice cubes, one cup for measuring, six unblemished cups, one stopwatch, one hot water source, three tablets of Alka-Seltzer, one thermometer that measures from negative

In this particular experiment the constant condition, the factor that was never changed, was the room temperature water. The independent variable, the variable the student affected, was how much water was placed into the beakers. The dependent variable, a variable that was affected by the independent variable, was the time it took for the tablet to fully dissolve. The control group, which did not receive treatment from the students, was the 50 ml of water as a result of being the medium between the three measurements of water. Finally, the experimental group, the subject that was exposed to the variable during the experiment, was the 25 ml and 75 ml of

Research Question: To investigate and compare how different temperature (5℃, 15℃, 25℃, 35℃, 45℃) can affect the concentration of carbon dioxide in soda water through titration with sodium hydroxide solution. Introduction: Carbon dioxide plays an important role in soft drinks. Soda water is manufactured by pumping carbon dioxide into water under high pressure. Carbon dioxide dissolves in water to form carbonic acid, which is the fizz we find in soft drinks. CO2 + H2O ⇌

How does the amount of baking soda mixed with vinegar affect the volume of gas produced per 10 seconds? A reaction is when (usually) a solute acts on a solvent to create a reaction. An example of a reaction is an explosion, Here we will be using baking soda and vinegar which are our two components which will cause for a reaction to take place. Reactions can be affected by several things such as temperature, concentration and the presence or absence of a catalyst which is a substance which can increase the rate of reaction.

Stoichiometry is a method used in chemistry that involves using relationships between reactants and products in a chemical reaction, to determine a desired quantitative data. The purpose of the lab was to devise a method to determine the percent composition of NaHCO3 in an unknown mixture of compounds NaHCO3 and Na2CO. Heating the mixture of these two compounds will cause a decomposition reaction. Solid NaHCO3 chemically decomposes into gaseous carbon dioxide and water, via the following reaction: 2NaHCO3(s) Na2CO3(s) + H2O(g) + CO2(g). The decomposition reaction was performed in a crucible and heated with a Bunsen burner.

Lab Report Experiment 6 Rates of Chemical Reactions By Nikhola Mirashirova Lab Partner: Dina Abetova Section 3, Saturday October 31, 2015 Introduction Rate reaction is the measure of the change in concentration of the reactants or the change in concentration of the products per unit time.1,2 Rate law for this experiment: Rate = k(I-)m(BrO3-)n(H+)p There are several factors which affect the rate of reaction: catalyst, reactant concentration, and temperature.1,2 A catalyst is a substance that changes, increases or decreases, the rate of a chemical reaction but is not being used up during the reaction.3 It provides an alternative way, so that the rate of reaction changes.4 Catalyst, which is used in this experiment, is (NH4)2MoO (0.5 M).

VARIABLES: There are independent variables, dependent variables, and controls. the one that is being tested and the one that is the inconsistent variable in the Independent variable like the volume and surface area of the agar cubes. The variable that is kept consistent is the dependent variable such as the percentage of diffusion of pigment in the agar cubes. The constant variable is the features of the experiment that is kept the same throughout the entire experiment such as, the amount of time the agar cubes are left in the beaker and the amount of acid in the beaker.

The equation of the reaction between sodium hydroxide and ethanoic acid is as follows: CH3COOH + NaOH → CH3COONa + H2O We can measure the end point of titration process and we can also measure the amount of reactants. The concentration of ethanoic acid in the vinegar can be determined through stoichiometric calculations, Using the values obtained from the titration, and also the chemical equation as a reference. Phenolphthalein indicator is used in this acid-base titration Equipment and materials:

Aim: To find out the relationship between the greater concentration of sodium thiosulfate when mixed with hydrochloric acid and the time it takes for the reaction (the time it takes for the solution to turn cloudy) to take place and to show the effect on the rate of reaction when the concentration of one of the reactants change. Introduction: The theory of this experiment is that sodium thiosulfate and hydrochloric acid reach together to produce sulfur as one of its products. Sulfur is a yellow precipitate so, the solution will turn to yellow color while the reaction is occurring and it will continue until it will slowly turn completely opaque. The reaction of the experiment happens with this formula: “Na2 S2 O3 + HCL =

Silica which is soluble in about 2 to 3N hydrochloric acid can be taken as reactive silica. The acid-soluble silica can easily and accurately be determined by plasma emission spectrometry using a very small quantity of fly ash (Sivapullaiahet al. 1998). 3.3. Soil – Lime Reactions The addition of lime to a soil initiates a two stage reaction.

Introduction The goal of the experiment is to examine how the rate of reaction between Hydrochloric acid and Sodium thiosulphate is affected by altering the concentrations. The concentration of Sodium thiosulfate will be altered by adding deionised water and decreasing the amount of Sodium thiosulphate. Once the Sodium thiosulphate has been tested several times. The effect of concentration on the rate of reaction can be examined in this experiment.