Sodium Bromide And 1-Butanol Lab Report

After 28 minutes, the mixture stopped boiling, and approximately 4.5 ml of bromobenzene was added drop by drop in the mixture, and color of the mixture was turned light brown orange. Then, the phenylmagnesium bromide was cooled in ice bath for a few minutes, and 10 ml of anhydrous diethyl ether was added in the mixture by using the syringe. After that, approximately 2.3 ml of methyl benzoate was added to the reaction, and it was added slowly slowly because the reaction was exothermic which needed to be cool in order to maintain a gentle reflux. Once all the methyl benzoate solution was added, the heating mantle was removed from the reaction flask and was cooled to the room temperature. During the reaction, a milky white salt began to precipitate, and the reaction flask was swirled for ten minutes until most of the reaction became visibly subdivided.

1. Identify the range of senses involved in communication • Sight (visual communication), Touch (tactile communication), Taste, Hearing (auditory communication), Smell (olfactory communication) 2. Identify the limited range of wavelengths and named parts of the electromagnetic spectrum detected by humans and compare this range with those of THREE other named vertebrates and TWO named invertebrates. Figure 1: the electromagnetic spectrum source: www.ces.fau.edu Vertebrates Human Japanese Dace Fish Rattlesnake Zebra Finch Part of electromagnetic spectrum detected ROYGBV (visible light) detected by light sensitive cells in the eye called rods and cones.

The lab started off by measuring critical materials for the lab: the mass of an an empty 100 mL beaker, mass of beaker and copper chloride together(52.30 g), and the mass of three iron nails(2.73 g). The goal of this experiment is to determine the number of moles of copper and iron that would be produced in the reaction of iron and copper(II) chloride, the ratio of moles of iron to moles of copper, and the percent yield of copper produced. 2.00 grams of copper(II) chloride was added in the beaker to mix with 15 mL of distilled water. Then, three dry nails are placed in the copper(II) chloride solution for approximately 25 minutes. The three nails have to be scraped clean by sandpaper to make the surface of the nail shiny; if the nails are not clean, then some unknown substances might accidentally mix into the reaction and cause variations of the result.

As the name implies, the bromination mechanism in an electrophilic aromatic substitution reaction that replaces an atom on the ring with a bromine atom. The addition of the bromine is driven by the presence of a Lewis acid catalyst and a bromine atom. In most bromination mechanisms, liquid bromine is the preferred reagent to complete the reaction. However, due to potential safety concerns, the aromatic ring was brominated by using a compound of hydrobromic acid and potassium bromate in an acetic acid solution (see Figure 2 for the bromine formation).1 Liquid bromine is known for generating hazardous fumes, so this solution is significantly safer for bromine production. This formation of bromine is crucial for the bromination reaction to

The goal of the experiment is to synthesize a bromohexane compound from 1-hexene and HBr(aq) under reflux conditions and use the silver nitrate and sodium iodide tests to determine if the product is a primary or secondary hydrocarbon. The heterogeneous reaction mixture contains 1-hexene, 48% HBr(aq), and tetrabutylammonium bromide and was heated to under reflux conditions. Heating under reflux means that the reaction mixture is heated at its boiling point so that the reaction can proceed at a faster rate. The attached reflux condenser allows volatile substances to return to the reaction flask so that no material is lost. Since alkenes are immiscible with concentrated HBr, tetrabutylammonium bromide is used as a phase-transfer catalyst.

Abstract In this experiment, the reaction kinetics of the hydrolysis of t-butyl chloride, (CH3)3CCl, was studied. The experiment was to determine the rate constant of the reaction, as well as the effects of solvent composition on the rate of reaction. A 50/50 V/V isopropanol/water solvent mixture was prepared and 1cm3 of (CH3)3CCl was added. At specific instances, aliquots of the reaction mixture were withdrawn and quenched with acetone.

The purpose of this experiment is to perform a two step reductive amination using o-vanillin with p-toluidine to synthesize an imine derivative. In this experiment, 0.386 g of o-vanillin and 0.276 g of p-toluidine were mixed into an Erlenmeyer flask. The o-vanillin turned from a green powder to orange layer as it mixed with p-toludine, which was originally a white solid. Ethanol was added as a solvent for this reaction. Sodium borohydride was added in slow portion as the reducing agent, dissolving the precipitate into a yellowish lime solution.

On April 6, 2016 at approximately 11:45am, a local police station got a call about a hostage situation at a local pharmacy. When police and medical examiners got to each crime scene, they learned that all of the hostages were given drugs and had overdosed on them. Some of the pills, in powder form, were found near the victims. One of the victims was stable enough to tell the investigators that the power on the floor were the drugs they were forced to take. The medical examiner found out each hostage was given either unknown A or unknown B.

2.4 Band Division and Energy Computation: The power spectrum of the signal is multiplied by magnitude response of set of 33 triangular band pass filters and in the range 300Hz-2000Hz. Sub-bands are formed by using the logarithmic spacing. The positions of these filters are equally spaced along the Mel frequency, which is related to the common linear frequency f by following formula: Mel (f) = 1125* ln (1+f/700) (3) Mel frequency is proportional to the logarithm of linear frequency and which is close to the human perceptual system. 2.5 Sub Fingerprint Generation:

The Gastrocnemius Muscle of Rana pipiens is an Appropriate Model for Skeletal Muscle Contractile Kinetics When Compared to Peer-Reviewed Models Georgia Institute of Technology BMED 3110: Quantitative Engineering Physiology Laboratory I Section B: Team Baboons 16 November 2014 ABSTRACT The dynamics of skeletal muscle kinetics can be quantified using various experimental methods involving stimulated muscle contractions.

Tn 4351 was originally isolated from bacteroides fragilis [30] . The transposon was successfully introduced into Cytophaga succinicans, Flavobacterium meningosepticum, Flexibacter canadiansis, Flexibacter strain SFI and Sporocytophaga myxococcoides by conjugation [25]. Tn 4351carries two antibiotic resistance gene. One of the codes for resistance to erythromycin and clindamycin which is expressed in bactroides but not in E.Coli. The other gene codes for resistance in tetracycline and is expressed in aerobically grpwn E. coli, but not in anaerobically grpwn E. coli or in bacteroides.

Note: make sure that you leave space between distillation take-off and the cylinder. This would allow you to observe the drops of the distillate that enter to Graduated Cylinder. Step 2: Begin distillation.

Properties of Substances Express Lab 1)The purpose of this lab was to compare the physical properties of different types of solids and how the properties of solids are determined by their intermolecular forces and their intramolecular bonds. Then we were to classify each type of solid as either ionic, metallic, non-polar molecular, polar molecular, or network. Paraffin wax classified as a non-polar molecular, Silicon dioxide was classifies as a network, Sodium chloride was classified as ionic, Sucrose was classified as polar molecular and Tin was classified as metallic. (2)The intermolecular forces that are present in Paraffin wax are dispersion forces, because it is non-polar and carries a negative charge. Followed by Sucrose that has

Properties of Ionic and Covalent Substances Lab Report Introduction The purpose of this lab was to determine which of the following substances: wax, sugar, and salt, are an ionic compound and which are a covalent compound. In order to accurately digest the experiments results, research of definitions of each relating led to the following information: ionic compounds are positive and negatively charged ions that experience attraction to each other and pull together in a cluster of ionic bonds; they are the strongest compound, are separated in high temperatures, and can be separated by polar water molecules. A covalent compound forms when two or more nonmetal atoms share valence electrons; covalent compounds are also

Biochemical tests are the tests used for the identification of bacterial species based on the differences in the biochemical activities of different bacteria. Bacterial physiology differs from one species to the other. These differences in carbohydrate metabolism, protein metabolism, fat metabolism, production of certain enzymes and ability to utilize a particular compound help them to be identified by the biochemical tests. Gram’s stain was originally devised by histologist Hans Christian Gram in 1884. Gram-positive bacteria stain purple, while Gram-negative bacteria stain pink when subjected to Gram staining.